Industrial Blanket
It is a stone wool blanket that is used for thermal insulation and fire safety of industrial plants, process equipments, large diameter pipes.
Application Area
- Care should be taken to ensure that the joints fit properly and no gap is left at the joints. During the application on large surfaces, the blankets should be impaled over welded pins of 5-6 in number per square meter.
- There are three different types of industrial blankets available as 650, 700 and 750 with different technical properties.
Industrial Board
It is a stone wool board that is used for thermal insulation and fire safety of industrial plants, process equipments, steel construction buildings.
Stone Wool Prefabricated Pipe
It is a pipe unfaced or faced with aluminium foil and manufactured out of stone wool with high unit weight. It is used for the thermal insulation of industrial pipes of temparatures over 250 ˚C, for vibration and sound insulation of pressurized pipes and against frost in pipes.
Application Area
- ppropriate Stone Wool Prefabricated Pipe according to nominal diameter of the pipe line to be used is chosen. It is placed by parting cut line.
- The application is completed so that no gap is left between the joints. Unfaced pipes are coated with bituminous emulsion or bituminous membranes, galvanized or aluminium jacket.
Loose Stone Wool
Izocam Loose Stone Wool is manufactured from rock fibers which are free from binders and other impurities. It is used for thermal and sound insulation of amorphous surfaces with high temperatures, double-walled cups, laboratory equipments and household electric appliances.
Application Area
- It is applied to the amorphous spaces where stone wool industrial blankets and boards cannot be used, by method of stuffing. It prevents thermal losses resulting from the gaps which couldn’t be filled with other insulation materials.
- It can be used for fire insulation purpose of the electrical cables and installments as well.
Duct Board
It is a glass wool board faced with aluminium foil or black glass tissue on one side used for external thermal insulation, internal sound insulation of air conditioning and ventilation ducts.
Application Area
- According to the purpose of the application, it is decided which duct board is going to be used.
- One type of board is chosen among unfaced board, board faced with aluminium foil and board faced with glass tissue.
- Before the boards are applied, duct surfaces to be used are cleaned to make sure the surface is free from dust and grease.
- If cold air insulation is going to be applied for the external thermal insulation, definitely the boards faced with aluminium foil should be used against condensation risk. The boards are installed into the pins (5- 6 pins per m2) fastened to the outside of the duct with foiled side facing the exterior.
- Board joints are sealed with self adhesive aluminium foil tape with great care to ensure that joints are water impermeable.
- When both thermal insulation and sound insulation are required for the ducts, duct board faced with glass tissue on the inside should be preferred. In that case, boards are installed to the pins which were fastened to the ducts from the inside so that the side with glass tissue faces inside.
Valve Jacket
Izocam Valve Jacket is an insulation jacket specially manufactured for valves. It is manufactured from noncohesive white glass wool blanket or stone wool industrial blanket, with silicone on the outer side and faced with silicone-free glass tissue which is resistant to 500 ˚C on the inside. İzocam Valve Jackets are used for thermal insulation of all kinds of valves (piston valve, globe valve, butterfly valve, etc.) which are manufactured according to DIN, ANSI and API standards and strainers at indoor and outdoor spaces.
A valve jacket is chosen according to the valve to be insulated or it is customly made. Valve jacket is wrapped around the valve and the hooks are tightly attached to each other by the help of the string. It is controlled if there is any vapour leak before the installation. If a leak is inspected, the installation takes place after the leak is fixed. Valve and flanges should be insulated totally and valve jacket should be mounted on the insulated pipe to which the valve is connected, minimum 50 mm beginning from the flanges.